SUPERFIXALL-Technical Data Sheet
Superfi xall is an exceptionally high strength, high quality waterproof cement based adhesive
developed to bond all types of ceramic tiles. Ideal for bonding monocottura and fully vitrifi ed
tiles, as well as natural stone, marble, granite and mosaic tiles onto brickwork, cement
render and concrete walls and fl oors. Suitable for both internal and external applications.
FEATURES & BENEFITS
High strength bond
Easy to spread
Thick and thin bed applications
All surfaces must be clean, dry, free from dust, grease, wax, oil, laitance curing compounds and all other
contaminants likely to prevent the adhesive bonding. Highly porous substrates must be primed with ASA
Multiprime prior to tiling. Concrete should be allowed to cure for at least 28 days and cement render 7 days prior
to tiling. A wood fl oat fi nish is preferred. Smooth steel trowel fi nished concrete must be mechanically abraided to
Movement joints must be incorporated in the tile layout in accordance with AS3958.1-1991 clauses 220.127.116.11 to 6.
20kg of Superfi xall powder requires approximately 5 litres of water which produces 14 litres of mixed product.
Add a measured amount of clean water into a clean container and sprinkle Superfi xall powder slowly into the
liquid with constant stirring. Eliminate lumps. Mix to a thick toothpaste consistency. Allow to stand for 2 minutes
then remix. The adhesive is now ready to use.
Apply the mixed adhesive to the prepared substrate using the appropriate notched trowel for the size of the tile
being laid. A minimum of 1mm bed thickness for walls and 3mm for fl oors must be achieved. Ensure that the
bedded tiles are fully supported by the adhesive with no voids underneath or behind. Lay tiles into the adhesive
before it skins. The adhesive may also need to be applied to the back of the tiles to accommodate the required
levels. Do not disturb tiles untill the adhesive has dried. Commence grouting after 24 hours when tilework is fi rm.
Use the appropriate ASA grout, allowing joint widths of 1.5mm to 6mm for walls and 3mm to 12mm for fl oors as
per AS3958.1-1991 clause 5.4.6.
Superfi xall can be removed from the surface of the tiles using a damp cloth while the adhesive is still wet. Tools
and equipment can be cleaned with warm water and detergent prior to adhesive drying.
Off White: 20kg paper bags and 5kg plastic bags. White: 20kg paper bags.
2.5 hours at 22°C and 50%RH Setting time: 24 hours at 22°C and 50%RH.
3kg powder per m² using a 6mm x 6mm notched trowel and 6kg powder per m² using a 12mm x 12mm notched
This product is non-toxic but contains cement. Use good occupational health and safety practices to avoid personal
contact. ASA recommend the use of dust masks, eye protection and wearing of gloves when handling this product.
For more detailed information refer to product MSDS.
Unopened bags can be stored for up to 12 months in a cool, dry and weatherproof environment. Bags must be
stored off the fl oor.
• Not suitable for tiling over fl exible substrates, such as fi brous cement sheeting, plasterboard and timber.
• Must be mixed with undiluted ASA Megalastic for areas where vibration, shrinkage or tile growth may occur.
• Recommended for tiling